Quick answer: the easiest way to hang outdoor shade cloth is to fasten it through its grommets to a frame you already have, such as pergola rafters, fence posts or a greenhouse frame, using zip ties, bungee ball ties or clips. For an open patio, run tensioned wire or cable between walls or posts and clip the cloth to it. Pull the cloth evenly from all sides so it doesn't sag or flap, and pick the shade rate before you buy: 30% for sun-loving vegetables, 50% for flowers and most greenhouses, 70% for patios and pergolas.
Before you start
- Pick the shade rate. Our guide to 30% vs 50% vs 70% vs 90% shade cloth matches each rate to plants, patios and pets.
- Measure the frame, not the ground. Measure the outside of the structure you'll attach to, then decide whether the cloth should sit inside the frame or wrap over its edges.
- Know your cloth. Our custom shade cloth is 150 GSM UV-stabilized knitted HDPE with bound edges and grommets, one every foot on the short sides and every two feet on the long sides.
Which hanging method fits your space
| Where | Best method | What you need |
|---|---|---|
| Pergola or arbor | Lay the cloth over the rafters and tie down through the grommets | UV-rated zip ties or bungee ball ties |
| Open patio between walls or posts | Stretch 2–4 tensioned wires or cables, clip the cloth on | Wire or cable, eye bolts, turnbuckles, clips |
| Raised beds and gardens | Build a simple post or hoop frame and fasten the cloth on top | Posts or PVC hoops, clips, zip ties |
| Greenhouse | Cover the outside of the frame and leave the vents clear | Clips, rope or bungee ties |
| Dog kennel or run | Tie the cloth over the top panel and down one sunny side | Zip ties; see our kennel shade guide |
Step by step: hanging shade cloth over a frame
- Check the frame. Make sure posts and rafters are solid. Shade cloth is breathable, but a large panel still catches wind.
- Lay the cloth out with the grommets facing up so you can reach them, and center it on the frame.
- Fasten one corner, then the opposite corner. Pull snug but don't overtighten yet.
- Fasten the other two corners, then work along each side, using every grommet.
- Even out the tension. Go around once more and tighten ties a little at a time until the cloth is flat with no loose pockets.
- Check after the first windy day and re-tighten any ties that have loosened.
Tips that make shade cloth last
- Use every grommet. Skipping tie points puts extra load on the ones you use.
- Avoid sharp edges. Wrap or pad metal corners where the cloth rubs.
- Give it a slight slope over a patio so rain runs off instead of collecting in the middle.
- Take it down before major storms and for the off-season if you don't need winter shade.
- Need rain protection? Shade cloth lets water through. For a pergola that stays dry, compare breathable vs. waterproof pergola covers.
Getting the right size
Browse ready-made sizes in our shade cloth collection, or order custom shade cloth in 30%, 50% or 70% cut to your exact measurements. Custom orders are made in 1–3 business days and ship within 3–7 business days from California. Custom-made items are final sale, so check our How to Measure guide first.
FAQ
Can I hang shade cloth without grommets?
You can use clip-on shade cloth clips anywhere along the edge, but grommets on reinforced edges hold better in wind and are faster to install.
Should shade cloth be tight or loose?
Snug and even. Loose cloth flaps and wears out at the tie points; overtightening one corner pulls the cloth out of square.
What do I use to tie down shade cloth?
UV-rated zip ties for a permanent install, bungee ball ties if you'll take it down seasonally, and wire or cable runs for spans without a frame.
Is shade cloth waterproof?
No. HDPE shade cloth is breathable, so rain and air pass through. That's why it stays cooler underneath than a solid tarp.