Quick answer: To put a shade sail over grass, a lawn or a deck with no walls nearby, use steel shade sail posts. On grass, set each post in a concrete footing (for a typical backyard sail, many installers go at least 2–3 ft deep and 12–18 in wide). On a deck, do not bolt a post to the deck boards; set it in its own footing next to the deck or through it to the ground. Use a 12 ft post for high corners and an 8 ft post for low corners so the sail has a slope.
Why a shade sail needs real posts
A tight shade sail pulls hard on every corner, and wind multiplies that pull. Garden stakes, umbrella stands, fence posts and deck railings are not built for that load. A steel post in a concrete footing is what turns an open lawn or deck into a safe anchor point. Read the full shade sail poles guide for how the forces work.
Posts on grass or a lawn
- Lay out the sail. Mark each corner with a stake, then move the post marks a little outward so the hardware has room to tension the sail. Our sizing guide explains how much.
- Call 811 before you dig to locate buried lines.
- Dig the footing. Depth depends on soil, sail size and your frost line. Go deeper and wider for big sails, loose soil or windy sites, and lean each hole slightly away from the sail.
- Set the anchor and pour concrete. Our 12 ft and 8 ft stainless steel posts come with a reinforced anchor frame that goes into the wet concrete and a 7.75 x 7.75 in base plate for the post.
- Let it cure fully before you bolt on the post and tension the sail.
Posts on or next to a deck
Deck boards and joists are not designed to resist the sideways pull of a sail, so a post should not be screwed to the deck surface. Instead:
- Beside the deck: set the post in a ground footing just outside the deck edge. This is the simplest option.
- Through the deck: cut an opening in the boards and run the post down to a footing in the ground, leaving a small gap so the deck can move.
- Use the house: one or two corners can often go to a strong wall or fascia, with posts only on the open side. See how to install a shade sail on a deck.
Which posts to buy
| Setup | What you need |
|---|---|
| Triangle sail, one open corner | One 12 ft post |
| Square or rectangle sail off the house | Two 12 ft posts |
| Sloped sail in the middle of the lawn | One 12 ft + one 8 ft post, plus anchors for the other corners |
Every post includes the anchor frame, base plate, clamp and support cables. You will also need corner hardware: see our hardware kits.
FAQ
Can I put a shade sail post in the ground without concrete?
Not safely. Without a concrete footing, the pull of a tensioned sail can lean or lift the post, especially in wind or wet soil.
How tall should shade sail posts be?
Most backyard sails use 8–12 ft posts. Use a taller post on the high corners and a shorter one on the low corners so rain runs off and the sail does not flap.
Can I attach a shade sail to my deck railing?
No. Railings are built to stop people falling, not to hold a sail under wind load. Use a post in its own footing or a strong wall instead.
Do I need a permit for shade sail posts?
It depends on your city and the size of the sail. Many backyard sails do not, but large or commercial sails often do. Check with your local building department.